DPO is measured on one day. The denominator is a year of cost of sales; the numerator is the payables balance on the last day of the period. So the number can be moved by what happens in the final five working days, and everyone who reads it knows to ask what happened in those five days.

Lever one: hold the last payment run

The oldest method. The run due in the final week slips into the new year. Closing payables go up and DPO goes up with them. Suppliers are paid late and notice. The number falls back the following month.

Auditors look for a closing balance that steps up against the monthly average and steps down again in January. In Australia and the UK a late run in June or December also lands in payment times reporting.

Lever two: extend terms behind a finance programme

The modern method. Suppliers move from 30 or 60 days to 90 or 120. A bank pays them early, so they tolerate it. Payables stay on the balance sheet for the longer period and DPO rises and stays risen.

This worked quietly for a decade. Since 2024, IAS 7 requires the arrangement to be disclosed, including the range of terms inside it against comparable payables outside it. The first disclosures from large consumer groups showed inside terms running to 120 and 180 days against 30 to 60 outside. That gap is now in the note. The note is what the auditor, the lender and the rating agency read first.

Lever three: change the method, not the date

The invoice is settled on the agreed day by commercial card. The supplier receives EFT in full. The buyer's cash leaves when the card statement is paid, which can be weeks into the new period. The supplier's date does not move. Nothing is disclosed as a supplier finance arrangement, because the standard excludes instruments used to settle directly with a supplier and names credit cards as the example.

What this does to reported DPO comes down to where the card balance is presented: in trade payables or in short-term borrowings. In payables, DPO rises. In borrowings, DPO is unchanged and the cash benefit is the same. The standards allow either; it is an accounting policy choice, and the auditor's view of it decides. That is not advice we give. What we can say is that the question is about presentation, it has two answers and it should be settled before the first period end rather than argued at it. The reading GlobalFinex B2B works from, with the references, is on the balance sheet treatment page.

What the auditor asks

Three questions, in roughly this order. Did closing payables step up against the run rate, and why? Are any payables inside a supplier finance arrangement, and is the disclosure complete, terms range included? Where is the card balance presented, and has the policy been applied consistently?

The first catches lever one. The second catches lever two. The third is the only question lever three raises, and it is about presentation, not substance.

The honest version

A DPO that is higher because suppliers are paid later is a cost pushed into the supply chain, and three jurisdictions now report on it. A DPO that is higher because a bank is in the middle is a financing, and the accounts now say so. A DPO that is higher because the buyer's cash leaves on a statement date while the supplier is paid on time is the only version where nobody else carries the cost.

The test is the same as for working capital generally. Does the supplier notice? If they do, the number is borrowed and will have to be given back. If they do not, it is yours.

The glossary

Days payable outstanding, defined

The formula, what a high or low number means, how it relates to the cash conversion cycle and why method matters as much as date.

Sources: IFRS Foundation, Supplier Finance Arrangements (Amendments to IAS 7 and IFRS 7). Payment Times Reporting Regulator, Australia. UK Reporting on Payment Practices and Performance Regulations. Published 2024 and 2025 annual reports of large consumer goods groups.